FIR 1 - INSPECTION REPORT

Permit Holder:	Standard Oil Co of LA			Well Name/No:	Umsted, Sid	Permit:	4365
Lease Name:	Umsted, Sid 23	Sec:	32	Twp:	15S	Range	15W
GPS Well Location:		Latitude:	33.37624	Longitude:	-92.67426	Field:	WILDCAT
Lease/Tank Battery:		Latitude:	0	Longitude:	0	County:	OUACHITA
Entrance from nearest 911 address, public street or highway

Status:

Completing New not producing Operating Old not producing Not found

Single well pad Mutiple well pad NA

Well equipment operational:	Equipment plumbed properly:	Excess equipment on lease:
Yes No NA	Yes No NA	Yes No

Signs:

At lease entrance:

Yes No

At tank battery:

Yes No NA

At well:

Yes No NA

Signage compliance:

Yes No

Tank Containment:

Earthen Metal ring Tank in tank No Tanks Other

Dimensions:

Length:

0

Width:

0

Diameter:

0

Height:

0

Capacity (bbls):

0

Capacity compliance:		Breaches/Erosion:		Excessive vegetation present:			Compliance agreement:
Yes No NA		Yes No NA		Yes No NA			Yes No NA

Containment Conditions:

Fluids Present:

Yes No

Produced fluids Storm water Waste oil NA Other

Well Site Compressor:

Yes No

Is it in compliance?

Yes No NA

Trash/Debris:	Yes No	Use as storage area:	Yes No	Unusual equipment:	Yes No	Excessive erosion:	Yes No
If yes to any, explain:

Entry Gate Present:

Yes No

Gate locked on arrival:

Yes No

Gate locked on departure:

Yes No

Is spill or discharge of drilling, completion or produced fluids present:					Yes No
If yes, did spill or discharge of drilling, completion or produced fluids occur or travel off the well pad:								Yes No NA	(If yes, complete FIR 5)
Compliance Summary Remarks:
Checked well flow back pressure and it was 50psig. Started in the hole and tagged something around 703ft at 0820hrs. Installed power swivel and went down a couple joints and then removed the power swivel. Went back down and tagged again around 805ft and installed power swivel again. Went down a couple joints and removed power swivel again. Did not get anything back out of the well onto the screen. Started back down and the joints fell in smoothly and got down to 2403ft before tagging up on bottom. Total of 72 joints. Circulated for about an hour. Pulled tubing and collars out and removed the collars and installed 3 3/4" drill bit on the tubing and went back down the well bore. At around 24 joints in the oil rig shut down. Fuel filters seemed to have clogged around 1730hrs.

Inspected by:	GLEN OWENS				Date:  6/7/2022 8:56:00 AM
Review for NNC or NOV:	Yes No	If yes, check one	NNC NOV DNI NA	Ref #:	Date: __________
ADEQ referral:	Yes No	Date of referral:  __________